Seville STS V8-4.6L VIN 9 (1998)
1. Connect the air hose to the air compressor assembly at two places.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
2. Install the heat shield with three bolts.
Tighten three bolts to 4 Nm (35 inch lbs.).
3. Connect the air tube to the air dryer.
4. Install the air tube and harness tie on the heat shield with the bolt.
Tighten the bolt to 4 Nm (35 inch lbs.).
5. Install the compressor assembly onto the vehicle with two bolts and two nuts.
Tighten
^
Tighten two bolts to 9 Nm (80 inch lbs.).
^
Tighten two nuts to 9 Nm (80 inch lbs.).
6. Connect the air compressor connector to the vehicle harness connector.
