Seville STS V8-4.6L VIN 9 (1998)
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
6. Install the air tube and the harness tie onto the heat shield with the bolt.
Tighten the bolt to 4 Nm (35 inch lbs.).
7. Install the compressor assembly on the vehicle with two bolts and two nuts.
Tighten
^
Tighten the two bolts to 9 Nm (80 inch lbs.).
^
Tighten the two nuts to 9 Nm (80 inch lbs.).
8. Connect the air compressor connector to the vehicle harness connector.
9. Install the intake air filter in the vehicle.
Important: Before driving the vehicle, turn the ignition on and wait approximately 45 seconds. This will permit the ALC system to execute the
ARC, ensuring that the air adjustable shock absorbers are filled with residual pressure.
10. Lower the vehicle.
