Seville STS V8-4.6L VIN 9 (1998)
Transmission Speed Sensor: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the negative battery cable. Refer to Battery Disconnect Caution in Service Precautions.
2. Raise the vehicle. Refer to Vehicle Lifting.
3. Remove the electrical connector at the Vehicle Speed Sensor (VSS).
4. Remove the retaining bolt (131) and the sensor (130).
INSTALLATION PROCEDURE
1. Install the Vehicle Speed Sensor (VSS) (130) and the retaining bolt (131).
^
Tighten the bolt to 10 Nm (89 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the electrical connector at the sensor.
3. Remove the safety stands.
4. Lower the vehicle.
5. Connect the negative battery cable. Refer to Battery Disconnect Caution in Service Precautions.
^
Tighten the terminal bolt to 15 Nm (11 ft. lbs.).
