Seville STS V8-4.6L VIN 9 (1998)
7. Remove the hub and bearing retaining bolts and dust shield.
8. Place the transmission in PARK.
Important: The hub and bearing are replaced only as an assembly.
9. Using J 28733-B separate hub and bearing from the drive axle.
INSTALLATION PROCEDURE
Important: Clean rust and foreign material from the knuckle mounting face, bore and chamfer to allow for proper seating of the bearing and
knuckle.
1. Install the hub and bearing to the drive axle.
^
Apply a light coating of grease to the knuckle bore. If the new hub and bearing has a protective plastic cover, remove it before installation.
^
Do not handle the knuckle or hub assembly by the ABS sensor wire.
2. Install new drive axle nut and draw hub and bearing onto the axle.
3. Place the transmission in neutral.
4. Install the dust shield, taking care not to damage the bearing outboard lip seal.
