Seville STS V8-4.6L VIN 9 (1998)
2.2.
Carefully place the optical tape in the tray (3) with the exposed adhesive up. Ensure that the red tab rests in the cut-out notch of the tray.
2.3.
Apply primer B to the sensor using the applicator supplied in the kit. Follow the directions on the primer B applicator. Remove the excess
primer using the clean cloth included in the kit.
2.4.
Place the outside moisture sensor module onto the optical tape in the tray. Press down firmly for 10-15 seconds.
2.5.
Remove the outside moisture sensor module from the tray. Remove any air bubbles that are under the tape by pressing on the tape with your
fingers.
Do not move the optical tape on the outside moisture sensor module.
IMPORTANT: The temperature of the windshield must be 30.5°C (50°F) to 55.5°C (100°F) for proper adhesion. If the windshield is installed in
the vehicle, cover the instrument panel with a protective cloth.
3. Install the outside moisture module to the windshield. Complete the following steps:
3.1.
Clean the area of the windshield where the outside moisture sensor module will be installed.
Use the cloth and cleaning solution included in the service kit in order to clean the windshield.
IMPORTANT: Properly position the outside moisture module prior to attaching the outside moisture sensor module to the windshield. The
outside moisture module may not be moved once the outside moisture module is in contact with the windshield.
3.2.
Remove the red backing from the optical tape. Immediately install the outside moisture sensor module onto the windshield.
3.3.
Push the outside moisture sensor module firmly against the windshield Hold the outside moisture sensor module in place for 10-15 seconds.
3.4.
Inspect for air bubbles between the tape and the windshield. Repeat the previous step under the following conditions:
^
The outside moisture sensor did not adhere to the windshield.
^
There are air bubbles between the tape and the windshield.
4. Connect the connector to the outside moisture sensor module. Do not move the outside moisture sensor module once the outside moisture sensor
module is on the windshield.
5. Remove the tape or marked lines from the windshield.
6. Inspect the operation of the outside moisture sensing wiper system. Refer to Wiper/Washer System Check (Rainsense).
