SRX 2WD V8-4.6L VIN A (2004)
Antenna Control Module: Service and Repair
TV Antenna Module Replacement
TV ANTENNA MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the right rear body side trim panel.
2. Remove the nuts (1) securing the module to the vehicle.
3. Disconnect the electrical connectors.
4. Remove the module.
INSTALLATION PROCEDURE
1. Connect the electrical connectors.
2. Locate the module the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the nuts (1) securing the processor to the vehicle.
Tighten
Tighten the nuts to 9 N.m (80 lb in).
4. Install the right rear body side trim panel.
