SRX 2WD V8-4.6L VIN A (2004)
Rear Bumper Cover / Fascia: Service and Repair
Fascia Replacement - Rear Bumper
Removal Procedure
1. Remove the rear wheelhouse liner.
2. Remove the push-in retainers.
3. Open the liftgate.
4. Remove the bolts (1) securing the fascia (2) to the rear end panel.
5. Remove the bolts (3) securing the fascia to the horizontal joint at the quarter panel (4).
6. Remove the fascia by sliding rearward to disengage the fascia from the rear bumper brackets.
7. Disconnect the electrical connector, if equipped.
