SRX 2WD V8-4.6L VIN A (2004)
1. Install the bullet end of the sunshade cable to the end of the U-channel (3). The U-channel is located on the front of the track assembly (2).
2. Push the cable into the U-channel until the barrel end of the cable reaches 25 mm (1 in) from the end of the U-channel.
3. Use a flat-bladed tool (3) to push the cable (2) through the channel.
4. Push the cable until the cable barrel is approximately 32 mm (1.25 in) from the end of the sunroof track from the rear.
