SRX 2WD V8-4.6L VIN A (2004)
Seat Cushion: Procedures
Seat Cushion Heater Element Replacement - Front
SEAT CUSHION HEATER ELEMENT REPLACEMENT - FRONT
The heater element is not serviced separately. The heater element is part of the seat cover, the seat cover and heater element must be replaced as an
assembly.
Seat Cushion Replacement - Front
SEAT CUSHION REPLACEMENT - FRONT
REMOVAL PROCEDURE
CAUTION: Refer to SIR Caution in Service Precautions.
1. Disable the SIR System. Refer to SIR Disabling and Enabling Zone 7 driver's seat and SIR Disabling and Enabling Zone 9 and passenger seat.
2. Move the seat to the full forward position.
3. Remove the retaining nuts (1) securing the seat cushion to the seat adjuster assembly.
4. Lift the front of the seat cushion upwards.
5. Remove the power seat switches.
NOTE: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.
6. Disconnect the wiring harness fastener and retainers securing the wiring harness to the bottom of the seat cushion frame.
7. Pull the cushion forward in order to remove the seat cushion from the seat adjuster assembly.
INSTALLATION PROCEDURE
