SRX 2WD V8-4.6L VIN A (2004)
2. Connect the low coolant sensor electrical connector.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the surge tank nut.
^
Tighten the nut to 9 Nm (80 inch lbs.).
4. Install the surge tank bolt.
^
Tighten the bolt to 9 Nm (80 inch lbs.).
5. Important: Lubricate the inside diameters of the hoses with clean coolant prior to installation.
Connect the surge tank inlet hose to the surge tank.
6. Using the J 38185, reposition the hose clamp to secure the surge tank inlet hose.
7. Connect the surge tank outlet hose.
8. Using the J 38185, reposition the hose clamp to secure the surge tank outlet hose.
9. Connect the master cylinder fluid level sensor electrical connector.
10. Fill the cooling system.