SRX 2WD V8-4.6L VIN A (2004)
1. Position the right secondary camshaft drive timing chain shoe in through the right front cylinder head as shown.
2. Notice: Refer to Fastener Notice.
Install the right secondary camshaft drive chain shoe bolt.
Tighten the secondary camshaft drive chain shoe bolt to 25 Nm (18 ft. lbs.).
3. Install the right exhaust actuator to the secondary chain, ensuring that the actuator timing mark is aligned with the chain link that was marked
during disassembly.
4. Loosely install the oil control valve to secure the exhaust actuator to the camshaft.
5. Notice: Refer to Torque Reaction Against Timing Drive Chain Notice in Service Precautions.
Use an open-end wrench on the hex cast into the camshaft in order to prevent the camshaft from rotating when tightening the oil control valve.
Tighten the oil control valve to 120 Nm (89 ft. lbs.).
