SRX 2WD V8-4.6L VIN A (2004)
Blower Motor Switch: Service and Repair
Blower Motor Switch Replacement - Auxiliary (Rear)
BLOWER MOTOR SWITCH REPLACEMENT - AUXILIARY (REAR)
REMOVAL PROCEDURE
IMPORTANT: Gently pull downward at the front edge of the center dome lamp assembly to disengage the fasteners.
1. Remove the center dome lamp assembly.
2. Disconnect the auxiliary blower motor switch (1) electrical connector.
3. Disconnect the dome lamp electrical connectors.
4. Remove the auxiliary blower motor switch (1) screws.
5. Remove the auxiliary blower motor switch (1) from the dome lamp housing.
INSTALLATION PROCEDURE
1. Install the auxiliary blower motor switch (1) to the dome lamp housing.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the auxiliary blower motor switch (1) screws.
Tighten
Tighten the screws to 1 N.m (9 lb in).
3. Connect the auxiliary blower motor switch (1) electrical connector.