SRX 2WD V8-4.6L VIN A (2004)
14. Disconnect the suction hose from the suction pipe.
15. Remove the suction hose from the vehicle.
16. Remove and discard the O-rings on the suction hose.
INSTALLATION PROCEDURE
1. Install new O-rings onto the suction hose.
2. Install the suction hose.
3. Connect the suction hose to the suction pipe.
4. Install the suction hose quick connect fitting.
5. Position the suction hose into the bracket
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the suction hose retaining screw into the bracket.
Tighten
Tighten the screw to 6 N.m (53 lb in).
7. Install the air cleaner outlet duct.
8. Raise and support the vehicle.