SRX 2WD V8-4.6L VIN A (2004)
A.
Carefully rotate the tool to move the adjustable pedal to the full forward position.
B.
Remove the square drive tool.
4.
Connect the adjustable accelerator pedal cable (1) to the pedal assembly.
5.
Ensure that the adjustable accelerator pedal cable retaining feature is locked in place by carefully pulling on the cable.
6.
Connect the electrical connector to the linear position sensor. Be sure the connector retainer is reinstalled into the appropriate hole in the bracket.
7.
Connect the electrical connector to the electronic throttle control sensor (3).
8.
Install the accelerator pedal assembly to the mounting studs.
9.
Install the accelerator pedal assembly mounting nuts (4).
Tighten
Tighten the accelerator pedal assembly mounting nuts to 9 Nm (80 lb-in).
10.
Operate the accelerator pedal and observe the APP angles using a scan tool. The accelerator pedal should operate freely, without binding between
closed throttle and wide open throttle.
11.
Align the tabs (1) to the I/P carrier in order to install the knee bolster bracket.
12.
Install the screws (2) securing the knee bolster bracket to the I/P.
Tighten
Tighten the fasteners to 9 Nm (80 lb-in).
