SRX 2WD V8-4.6L VIN A (2004)
3.
Connect the accelerator pedal electrical connector (1).
4.
Check for complete throttle opening, and throttle closing positions by operating the accelerator pedal. Monitor the throttle angles using a scan tool.
The accelerator pedal should operate freely without binding between full closed throttle and wide-open throttle.
5.
Check for an incorrect carpet fit under the accelerator pedal.
6.
Insert the I/P courtesy lamp down through the opening in the closeout panel.
7.
Install the closeout panel into position.
8.
Secure the closeout panel push-in retainers to the I/P lower support beam.
9.
Secure the notch in the right forward edge of the closeout panel to the tab on the accelerator pedal bracket. Align, and then push up to secure the
panel.
10.
Install the push-on retaining nut to the steering column bracket stud.
11.
Align the I/P courtesy lamp to the closeout panel opening, and then push to secure the lamp.
Pontiac Grand Prix
Removal
Notice:
Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle
control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control
components in cleaning solvents of any type.
1.
Remove the 3 closeout panel fasteners.
2.
Rotate the lamp. Remove the lamp from the panel.
