SRX 2WD V8-4.6L VIN A (2004)
16.
Disconnect the wiring harness connector from the SDM (1).
17.
Remove the SDM mounting fasteners (2).
18.
Remove the SDM from the console floor.
Installation
1.
Remove any dirt, grease, or other impurities from the mounting surface.
2.
Install the SDM (1) horizontally to the console floor.
3.
Point the arrow on the SDM toward the front of the vehicle.
4.
Install the SDM mounting fasteners (2).
Tighten
Tighten the fasteners to 9 Nm (80 lb-in).
5.
Connect the wiring harness connector (1) to the SDM.
6.
Push the flex lock button (3) down and move the sliding connector locking lever cover (4) to the CLOSE position.
7.
Install the CPA (1) to the wiring harness connector (2) to the inflatable restraint SDM.
