SRX 2WD V8-4.6L VIN A (2004)
Tighten to 20 Nm (15 lb ft), and then an additional 160 degrees.
17.
Connect the wheel speed sensor electrical connector to the bearing hub.
18.
Using the mark made earlier, align and install the brake rotor.
19.
Position the brake caliper and bracket to the knuckle and install the bolts.
Tighten
Tighten to 175 Nm (129 lb ft).
20.
Connect the height sensor linkage to the control arm.
21.
Place supports under the lower control arm to raise the arm to the normal curb height position.
Tighten
^
Tighten the FRONT lower control arm nuts to 145 Nm (107 lb ft).
^
Tighten the REAR lower control arm nuts to 95 Nm (70 lb ft).
23.
Remove the supports from the lower control arm.
24.
Repeat the procedure on the opposite side of the vehicle if necessary.
25.
Install the rear wheel and tire assemblies.
Tighten
Tighten the wheel nuts to 140 Nm (103 lb ft).
26.
Check the wheel alignment.
27.
Lower the vehicle.
