SRX 2WD V8-4.6L VIN A (2004)
10. Using the J 43631 , separate the lower control arm ball stud from the steering knuckle.
11. Remove the steering knuckle.
Installation Procedure
1. Install the steering knuckle to the lower control arm ball stud.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install a new lower control arm ball stud retaining nut.
1. Tighten the nut to 20 Nm (15 ft. lbs.).
2. Tighten the nut to an additional 210 degrees.
3. Install the upper control arm ball stud to the steering knuckle.
4. Install a new upper control arm ball stud retaining nut.
1. Tighten the nut to 20 Nm (15 ft. lbs.).
2. Tighten the nut to an additional 210 degrees.
