SRX 2WD V8-4.6L VIN A (2004)
Fluid Pump: Service and Repair
Automatic Transmission - 5L50-E
Transmission Fluid Bypass Valve Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Place a suitable drain pan under the transmission.
3. Remove the bolt and disconnect the transmission oil cooler lines from the bypass valve.
4. Remove the bolt from the oil cooler line retainer on the engine block. Position the oil cooler lines aside.
5. Remove the oxygen sensor wire bracket from the bypass valve stud and position the harness aside, if equipped.
6. Remove the bypass valve retaining bolt/stud.
7. Remove the bypass valve from the transmission.
Installation Procedure