SRX 2WD V8-4.6L VIN A (2004)
13. Remove the parking pawl spring.
14. Remove the parking pawl pivot pin.
15. Remove the parking pawl.
16. Inspect the following components:
^
The parking pawl tooth for chipping or wear
^
The parking pawl spring for over expansion
^
The pivot pin for scoring and excessive wear
Installation Procedure
1. Install the parking pawl (3).
2. Install the pivot pin (1).
3. Install the parking pawl spring (2). The straight end of the spring locates against the case and the hooked end locates over the parking pawl.
4. Install the extension housing.
5. Install the transmission support.
6. Remove the transmission jack.
7. Install the transmission fluid pan.
8. Remove the mechanics wire (2) securing the front propeller shaft (1) to the shift control lever (3).
9. Install the propeller shaft coupler (1) to the transmission flange.
10. Install the exhaust system.
