SRX 2WD V8-4.6L VIN A (2004)
5. Install a new small seal retaining clamp (2) onto the wheel drive shaft (3).
6. Slide the seal (1) onto the wheel drive shaft.
7. Place the new large retaining clamp over the large end of the seal (3).
8. Install the new wheel drive shaft large retaining ring onto drive shaft.
9. Seat the new wheel drive shaft large retaining ring into the large ring groove.
10. Install the new wheel drive shaft small retaining ring onto drive shaft.
11. Seat the new wheel drive shaft small retaining ring into the small ring groove.
12. Push the inner joint assembly (2) onto the wheel drive shaft until the small retaining ring (3) seats itself in the retaining groove on the wheel drive
shaft.
13. Insert the remaining grease from the service kit into the seal.
