SRX AWD V6-3.0L (2010)
Pedal Positioning Sensor: Service and Repair
Brake and Accelerator Pedal Adjuster Position Sensor Replacement
Brake and Accelerator Pedal Adjuster Position Sensor Replacement
Removal Procedure
Note: Move the adjustable pedal assembly to the full forward, front of vehicle position prior to removing components. Failure to place the adjustable
pedal assembly in the full forward position may result in incorrect accelerator and brake pedal step-over height and improper adjustable pedal function.
1. Move the adjustable pedal assembly to the full forward, front of vehicle position.
2. Remove the driver knee bolster panel. Refer to Driver Knee Bolster Panel Replacement (See: Restraint Systems/Knee Diverter/Service and
Repair).
3. Release the brake and accelerator pedal adjuster position sensor harness from the brake pedal bracket clip (1).
4. Disconnect the brake and accelerator pedal adjuster position sensor harness electrical connector (2).