SRX AWD V6-3.0L (2010)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning (See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Warning).
Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution (See: Service Precautions/Vehicle Damage Warnings).
Caution: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to
observe this precaution could result in damage to the EBCM/EBTCM.
1. Place the ignition switch in the OFF position.
2. Without draining the coolant or removing the hoses, remove and position aside the radiator surge tank. Refer to Radiator Surge Tank Replacement
(LF1) (See: Engine, Cooling and Exhaust/Cooling System/Coolant Reservoir/Service and Repair/Radiator Surge Tank Replacement)Radiator
Surge Tank Replacement (LAU) (See: Engine, Cooling and Exhaust/Cooling System/Coolant Reservoir/Service and Repair/Radiator Surge Tank
Replacement).
Note: Lift the dash panel insulator slightly to remove the upper master cylinder heat shield nut.
3. If equipped with the master cylinder heat shield, remove the master cylinder heat shield nuts (1).
