SRX AWD V6-3.0L (2010)
1. Install the brake caliper bracket (1).
2. Prepare the brake caliper bracket bolts and the bracket threaded holes for assembly:
*
Thoroughly clean the residue from the bolt threads with denatured alcohol or equivalent and allow to dry.
*
Thoroughly clean the residue from the threaded holes with denatured alcohol or equivalent and allow to dry.
*
Apply threadlocker to 2/3 of the threaded length of the caliper bracket bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers (See:
Specifications/Fluid Type Specifications).
*
Ensure there are no gaps in the threadlocker along the length of the filled area of the bolts.
*
Allow the threadlocker to cure approximately 10 minutes before installation.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the brake caliper bracket bolts (1) and tighten to 110 Nm (81 lb ft).