SRX AWD V6-3.0L (2010)
*
Allow the threadlocker to cure approximately 10 minutes before installation.
9. Position the brake caliper and bracket assembly to the vehicle.
10. Install the brake caliper bracket bolts (1) and tighten to 110 Nm (81 lb ft).
11. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
Rear Brake Rotor Replacement
Rear Brake Rotor Replacement
Special Tools
*
CH-41013 - Rotor Resurfacing Kit
*
CH-42450-A - Wheel Hub Resurfacing Kit
For equivalent regional tools, refer to Special Tools (See: Tools and Equipment).
Removal Procedure
Warning: Refer to Brake Dust Warning (See: Service Precautions/Technician Safety Information/Brake Dust Warning).
1. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling (See: Parking Brake System/Parking Brake
Cable/Service and Repair/Procedures/Parking Brake Cable Adjuster Disabling).
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).