SRX AWD V6-3.0L (2010)
4. Remove the master cylinder heat shield bolt (1).
5. Remove the master cylinder heat shield.
6. Disconnect the electronic brake control module (EBCM) electrical connector.
7. Disconnect the left rear brake pipe fitting (1) at the brake pressure modulator valve (BPMV).
8. Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
9. Disconnect the right rear brake pipe fitting (2) from the BPMV.
10. Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
