SRX AWD V6-3.0L (2010)
Vacuum Brake Booster: Service and Repair
Power Vacuum Brake Booster Replacement
Removal Procedure
1. Remove the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Insulator Panel Replacement - Left Side).
2. Disconnect the brake pedal position sensor electrical connector.
Note: Do not reuse the power vacuum brake booster pushrod retainer.
3. Release the power vacuum brake booster pushrod retainer (1) from the brake pedal arm by pulling the brake pedal rearward.
4. Discard the power vacuum brake pushrod retainer.
5. Disconnect the brake fluid level indicator switch electrical connector.