SRX AWD V6-3.0L (2010)
7. Remove the oil pressure sensor.
8. Install the J 21867 with the J-21867-6 .
9. Measure the engine oil pressure.
10. Compare the readings to the Engine Mechanical Specifications (LF1) (See: Specifications/Engine Mechanical Specifications)Engine Mechanical
Specifications (LAU or LBW) (See: Specifications/Engine Mechanical Specifications).
11. If the engine oil pressure is below specifications, inspect the engine for one or more of the following:
*
Loose oil filter adapter bolts
*
Missing or damaged oil filter adapter O-ring seal or seals
*
Worn or dirty oil pump
*
Loose oil pump-to-engine block bolts
*
Loose, plugged or damaged oil pump screen
*
Missing or damaged oil pump screen O-ring seal
*
Damage or leak in the oil pump screen suction tube
*
Malfunctioning oil pump pressure regulator valve
*
Missing or incorrectly installed oil gallery plugs
*
Loose camshaft intermediate drive shaft bolts
*
Excessive bearing clearance for the following:
-
Connecting rod or rods
-
Crankshaft
-
Camshaft or camshafts
-
Camshaft intermediate drive shaft sprocket
*
Cracked, porous or restricted oil galleries
*
Broken valve lifters
12. Repair or replace components as necessary.