SRX AWD V6-3.0L (2010)
Note: It may be easier to remove catalytic converter by removing the left cylinder studs.
5. Remove the exhaust bracket insulator (3) from the hanger and lower catalytic converter (5).
6. Carefully lower the catalytic converter to the floor.
7. Transfer oxygen sensors if replacing catalytic converter.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Caution: To prevent damage to the exhaust manifold flange or stud, make sure the flange is fully seated before tightening.
Note: Replace the left catalytic to cylinder head nuts and gaskets with new ones.
1. Install the left catalytic converter nuts to the left cylinder head. Tighten nuts (1) in a criss-cross pattern.
*
First Pass: 20 Nm (15 lb ft)
*
Final Pass: 46 Nm (34 lb ft)
