SRX AWD V6-3.0L (2010)
-
If you are unsure of the wire size, begin with the largest opening in the wire stripper and work down until achieving a clean strip of the
insulation.
*
Strip approximately 7.5 mm (0.313 in) of insulation from each wire to be spliced.
*
Do not nick or cut any of the strands. Inspect the stripped wire for nicks or cut strands.
*
If the wire is damaged, repeat this procedure after removing the damaged section.
4. For high temperature wiring, slide a section of high temperature SCT1 shrink tubing down the length of wire to be spliced. Ensure that the shrink
tubing will not interfere with the splice procedure.
5. Select the proper Dura Seal splice sleeve according to the wire size. Refer to the above table at the beginning of the repair procedure for the color
coding of the Dura Seal splice sleeves and the crimp tool nests.
6. Use the splice sleeve crimp tool in order to position the Dura Seal splice sleeve in the proper color nest of the splice sleeve crimp tool. The crimp
tool has four nests, one for each color.
7. Place the Dura Seal splice sleeve in the nest. Ensure that the crimp falls midway between the end of the barrel and the stop. The sleeve has a stop
(3) in the middle of the barrel (2) in order to prevent the wire (1) from going further. Close the hand crimper handles slightly in order to firmly
hold the Dura Seal splice sleeve in the proper nest.
8. Insert the wire into the splice sleeve barrel until the wire hits the barrel stop.
9. Tightly close the handles of the crimp tool until the crimper handles open when released.
The crimper handles will not open until you apply the proper amount of pressure to the Dura Seal splice sleeve. Repeat steps 4, 6 and 15 for the
opposite end of the splice.
