SRX AWD V6-3.0L (2010)
Position #4
4. Use CH-50623 to check the crimp diameter at all 4 crimp diameter pairs at each end (identified with arrows in the above illustration) of the
crimped section. Attempt to slide the CH-50623 over the crimp at 4 different locations, working your way around the crimp for a total of 8 checks
(4 checks at each end).
Note
Some undersized (unacceptable) crimp diameters near the gauge size may require the tool to be wiggled slightly for it to slide over the crimp.
Use feel, not excessive force to perform this step.
Note
The crimp diameter check must be performed on the surfaces between the crimp ridges.
Note
The illustration below shows the inspection being done on the crimp with the power steering gear inlet pipe/hose out of the vehicle for
demonstration purposes only. The procedure should be done with the power steering gear inlet pipe/hose in the vehicle.
A - Unacceptable Crimp, B - Acceptable Crimp