SRX AWD V6-3.0L (2010)
Fluid Line/Hose: Service and Repair
6T70/6T75 - Automatic Transmission
Transmission Fluid Cooler Pipe Connector Replacement - Radiator
Transmission Fluid Cooler Pipe Connector Replacement - Radiator
Removal Procedure
1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill LF1) (See: Engine, Cooling and Exhaust/Cooling
System/Service and Repair/Cooling System Draining and Filling (Static Fill))Cooling System Draining and Filling (GE 47716) (See: Engine,
Cooling and Exhaust/Cooling System/Service and Repair/Cooling System Draining and Filling (GE 47716))Cooling System Draining and Filling
(Static Fill LAU) (See: Engine, Cooling and Exhaust/Cooling System/Service and Repair/Cooling System Draining and Filling (Static Fill)).
2. Remove the transaxle oil cooler hoses from the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect
Fitting Disconnection and Connection (See: ).
Note: Do not remove the upper and lower transaxle oil cooler fittings from the radiator at the same time other wise the transaxle oil cooler will
fall inside the radiator end tank.
3. Remove the oil cooler fitting from the radiator.
Installation Procedure
1. Inspect the new O-ring seals for cracks, cuts or damage. Replace if necessary.
