SRX AWD V6-3.0L (2010)
production shim. DO NOT remove the production shim. The installation of two shims per side (production shim and service shim) is required.
23. Install the first shim (1) as shown in the illustration.
24. Install a new RDM bolt but do not tighten the bolt.
25. Remove the second RDM bolt. Discard the bolt.
Note
There is a production shim at each RDM bolt location. A second shim, which is provided in the service kit, must be placed on top of the
production shim. DO NOT remove the production shim. The installation of two shims per side (production shim and service shim) is required.
26. Install the second shim (1) as shown in the illustration.
27. Install a new RDM bolt but do not tighten the bolt.
28. Raise the RDM.
29. Tighten the two new RDM bolts to 40 Nm (30 lb ft) plus an additional 90 degrees.
30. Remove the jack from the work area.
31. Lower vehicle. Refer to Lifting and Jacking the Vehicle in SI.
