SRX AWD V6-3.0L (2010)
-
If the vehicle is equipped with an all-wheel drive system, refer to All-Wheel Drive Service Procedure in this bulletin.
Front Wheel Drive Service Procedure
No parts are required for this repair.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in SI.
2. Locate the transmission mount bolts.
1. Loosen the two bolts. Back out the two bolts several turns. Ensure that there is zero (0) torque on the two bolts.
2. Tighten the two bolts to 100 Nm (74 lb ft) plus an additional 135 degrees.
3. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in SI.
All-Wheel Drive Service Procedure
The Snubber Kit, P/N 20930100, is required for this repair.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in SI.
2. Locate the rear center bearing bracket (2).
