SRX AWD V6-3.0L (2010)
Note: Ensure that the boot clamp is properly positioned around the entire circumference of the boot.
7. Using the DT 35910 - pliers (1), close the clamp (2) until the gap (3) measures 2.15 mm (0.85 in).
Note: Ensure that the boot clamp is properly positioned around the entire circumference of the boot.
8. Using the CH 48894 - pliers (1), close the boot clamp (3).
9. Remove the wheel drive shaft from the bench vise.
10. Move the CV joint in a circular motion 4 to 5 times to distribute the lubricant.
11. Install the wheel drive shaft in the vehicle.
*
For the left wheel drive shaft, refer to Front Wheel Drive Shaft Replacement - Left Side (See: Service and Repair).
*
For the right wheel drive shaft, refer to Front Wheel Drive Shaft Replacement - Right Side (See: Service and Repair).
