SRX AWD V6-3.6L (2008)
Systems/Oxygen Sensor/Service and Repair) .
Important: Inspect the catalytic converter seal/heat shield sealing surface. Replace the seal/heat shield if the sealing surface is worn or
damaged.
2. Install the catalytic converter seal/heat shield to the catalytic converter.
3. Carefully install the catalytic converter to the exhaust manifold.
4. Install the catalytic converter nuts.
5. Connect the oxygen sensor electrical connector.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
Important: Inspect the catalytic converter seals. Replace the seals if they are worn or damaged.
6. Connect the muffler pipes to the left and right side catalytic converters.
Tighten the muffler nuts to 22 N.m (16 lb ft).
7. Lower the vehicle.
8. Tighten the catalytic converter to exhaust manifold fasteners.
Tighten the catalytic converter nuts to 50 N.m (37 lb ft).
9. Install the right bank exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Left Side (LY7 - Gas, 6 Cylinder, 3.6L,
SFI, V6) (See: Engine, Cooling and Exhaust/Exhaust System/Heat Shield/Service and Repair/Exhaust Manifold Heat Shield Replacement - Left
Side)Exhaust Manifold Heat Shield Replacement - Left Side (V8 w/LHD) (See: Engine, Cooling and Exhaust/Exhaust System/Heat
Shield/Service and Repair/Exhaust Manifold Heat Shield Replacement - Left Side (V8 w/LHD)) .
