SRX AWD V8-4.6L VIN A (2004)
IMPORTANT:
-
The adhesion promoter must be used to assure adequate bonding of the coupling.
-
Mask off or protect areas before applying the adhesion promoter.
3. Apply Glass Adhesion Promoter GM P/N 12378555 (Canadian P/N 88901239) to the rear window in the area where you will install the antenna
coupling. Follow the Glass Adhesion Promoter instructions on the product label.
IMPORTANT:
-
The RF connections for the inner antenna coupling should run parallel to the defogger gridline.
-
Align the inner and the outer antenna couplings.
-
Do not touch the adhesive backing on the antenna coupling.
4. Remove the protective film from the adhesive backing on the inner antenna coupling.
5. Align the inner antenna coupling either to the 4 locating marks on the rear window above the defogger gridline, or to the existing exterior
coupling.
6. Press firmly on all 4 corners and on the center of the antenna inner coupling (2) in order to ensure proper adhesion to the rear window (4). Hold
pressure on the inner coupling (2) for 10-30 seconds.
7. Ensure that no gaps occur between the couplings (2,5) and the rear window (4).
8. Connect the coaxial cable to the inner coupling (2).
9. Keep the vehicle dry. Allow 6 to 8 hours, at 15°C (60°F), for the adhesive to cure after installation.
