SRX AWD V8-4.6L VIN A (2004)
1. Prepare the mating surfaces as necessary.
2. Drill 8 mm (5/16 in) plug weld holes along the front edge of the service part. Locate these holes 13 mm (1/2 in) from the edge of the service part
spaced 40 mm (11/2 in) apart.
3. Drill 8 mm (5/16 in ) plug weld holes in the service part, as necessary, in the locations noted from the original panel. Do not drill holes in the
vertical flange along the wheelhouse area. This area will be bonded.
4. Apply 3M Weld-Thru Coating P/N 05913 or equivalent to all mating surfaces.
5. Apply bonding material Lord 108 to the vertical flanges in the wheelhouse areas only.
6. Install and align the service part using 3-dimensional measuring equipment.
7. Plug weld accordingly.
