SRX AWD V8-4.6L VIN A (2004)
1. Insert the seat belt through the garnish molding.
2. Insert the seat belt guide into the garnish molding.
3. Align the retainers on the garnish molding (1) with the holes in the body pillar.
4. Push the panel inward in order to secure the retainers.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the seat belt retractor anchor bolt (3). Ensure that the belt is not twisted.
Tighten
Tighten the bolt to 45 N.m (33 lb ft)
6. Install the seat belt retractor guide bolt (1). Ensure that the belt is not twisted.
Tighten
Tighten the bolt to 70 N.m (52 lb ft)
Garnish Molding Replacement - Center Pillar
GARNISH MOLDING REPLACEMENT - CENTER PILLAR
TOOLS REQUIRED
J 38778 Door Trim Pad Clip Remover
REMOVAL PROCEDURE
CAUTION:
