SRX AWD V8-4.6L VIN A (2004)
Sun Shade: Service and Repair
Sunroof Sunshade Motor/Actuator Replacement
SUNROOF SUNSHADE MOTOR/ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the center and front sunroof windows.
2. Disconnect the motor/actuator electrical harness from either the front (6) or rear (2) sunshade motor/actuator being serviced.
3. Remove the motor/actuator to motor/actuator block screws.
4. Pull the sunroof motor/actuator up. The motor/actuator may need to be rocked side-to-side in order to release the sunshade motor/actuator drive
gear from the cables.
5. Remove the sunshade motor/actuator.
INSTALLATION PROCEDURE
1. Pull the shade completely closed against the sunshade stops (3).
2. Inspect the gap of the shade's extended edge to the sunroof frame for even spacing.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the motor/actuator and screws.
Tighten
Tighten the screws to 5 N.m (44 lb in).