SRX AWD V8-4.6L VIN A (2004)
3. Remove all dirt and debris from the nut insert hole.
Important
Inspect the hole and surrounding area for any unseen damage, or fractures in the SMC frame material. If significant damage is evident, DO NOT
repair.
4. Apply two part epoxy (obtained locally) into the cleaned nut insert hole.
5. Install an M5 x 8 threaded allen bolt, or equivalent, into the new replacement nut insert. Thread the bolt to the end of the nut insert.
6. Thread the new nut insert into the epoxied hole. Ensure that the nut insert threads in straight, vertically.
7. Allow the new nut insert to cure for a minimum of 30 minutes (or follow manufacturer's guidelines), then remove the bolt from the nut insert.
8. Reinstall any original component removed.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer
