SRX AWD V8-4.6L VIN A (2004)
Use a body shop reciprocating saw or hack saw to cut the pin off above the sheet metal. Refer to the illustration above.
After removing the pin, inspect the area where the pin was. If you notice a hole in the sunroof frame, seal the hole with body seam sealer. Refer to the
illustration above.
Correction 3
Vehicles produced after December 1, 2006 with a VIN breakpoint of 70149506 will have a red protective cap over the front and rear sunroof guide pins.
The alignment pins should not have to be removed from the vehicle.
Lower the right rear corner of the headliner to gain access to the guide pin. Refer to the illustration above.
Slightly bend the sheet metal around the SMC guide pin for clearance. Refer to the illustration above.
Parts Information
Warranty Information
