SRX AWD V8-4.6L VIN A (2004)
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the rear track front extension screw (3, 5)
Tighten
Tighten the screws to 5 N.m (44 lb in).
7. Install the rear, center, and front windows.
8. Install the sunroof exterior trim covers to the side of the track that was serviced.
Sunroof Vent Window/Sunshade & Drive Tube Retainer Replacement
SUNROOF VENT WINDOW / SUNSHADE AND DRIVE TUBE RETAINER REPLACEMENT
REMOVAL PROCEDURE
1. Vent the rear window.
2. Open the rear sunshade.
3. Remove the headliner.
4. Remove the center and rear vent windows.
5. Remove the rear sunshade.
6. Loosen all of the rear track assembly screws.
7. Carefully pull downward the front edge of the rear track. (3).
8. Release the drive tube retainer from the drive tubes and the track.
9. Remove the retainer (3) from the sunroof track (5).