SRX AWD V8-4.6L VIN A (2004)
11. Rotate the EBCM connector tab (2) forward to the unlocked position.
12. Disconnect the EBCM electrical connector (1) from the EBCM and position out of the way.
13. Remove the front BPMV bracket nuts.
14. Remove the EBCM/BPMV assembly (1) from the BPMV bracket.
15. Remove and discard the 4 EBCM to BPMV screws.
16. Clean the surface of the EBCM/BPMV assembly.
17. Remove the EBCM (1) from the BPMV (2).
Installation Procedure
1. Clean the seal surface of the BPMV.
2. Install the EBCM (1) to the BPMV (2).
3. Make sure that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.
4. Notice: Refer to Fastener Notice in Service Precautions.
Important: Use New EBCM/BPMV screws after separating the EBCM from the BPMV.