SRX AWD V8-4.6L VIN A (2004)
1. Notice: Refer to Fastener Notice in Service Precautions.
Install the valve stem seal (2) over the threaded end of the bleeder valve (1).
2. Install the brake caliper bleeder valve (1).
Tighten the brake caliper bleeder valve to 14 Nm (124 inch lbs.).
3. Install the brake caliper bleeder valve cap.
4. Lubricate the new piston seals (1) with Delco Supreme II, GM P/N 12377967 (Canadian P/N 992667) or equivalent DOT-3 brake fluid from a
clean, sealed brake fluid container.
5. Install lubricated piston seals (1) into the brake caliper bore seal grooves.
6. Make sure the seals are not twisted.
7. Install the piston dust boot (2) over the end of the piston (3) so that the fold will face toward the brake caliper housing piston bore opening.
8. Seat the caliper dust boot into the brake caliper bore groove (1) and slide the piston into the brake caliper bore.