SRX AWD V8-4.6L VIN A (2004)
solenoid.
2.5.
Install the camshaft position actuator solenoid over the oil control valve.
2.6.
Install the alignment pin through the solenoid alignment hole and into the oil control valve alignment hole.
NOTE: Refer to Fastener Notice in Service Precautions.
2.7.
With the alignment pin in place, install the camshaft position actuator solenoid bolts.
Tighten
Tighten the camshaft position actuator solenoid bolts to 8 N.m (71 lb in).
2.8.
Remove the alignment pin.
2.9.
Install a NEW camshaft position actuator solenoid plug.
2.10.
Connect the electrical connector to the actuator solenoid.
2.11.
Install the fuel injector sight shield.