SRX AWD V8-4.6L VIN A (2004)
24.
Remove the upper-to-lower crankcase seals.
25.
Using a suitable scraper clean the anaerobic sealant from the rail surfaces of the block.
Service Procedure Steps 26 - 75
26.
Using a suitable cleaning tool clean out the anaerobic sealant from the engine block seal groove in the rail of the block.
27.
Using a suitable cleaning solvent clean the anaerobic sealant from the rail surfaces of the block.
28.
Using a suitable scraper clean the anaerobic sealant from the rail surfaces of the lower crankcase.
29.
Using a suitable cleaning solvent clean the anaerobic sealant from the rail surfaces of the lower crankcase.
30.
Ensure the surfaces to be sealed are free of anaerobic sealant and free of any nicks gouges or scratches. Repair or replace components as
necessary.
31.
Inspect all components removed for serviceability. Repair or replace components as necessary.
Important:
Ensure components being sealed with RTV sealant are assembled within 20 minutes. Components assembled after the RTV sealant has
skinned-over, approximately 20 minutes or longer, will not bond.
32.
Place a 5 mm (0.197 in) spot of RTV sealant P/N 12378521 (in Canada use P/N 88901148) used with a caulk gun or P/N 88861417 (in Canada
use P/N 88861418) used with sealant dispenser GE-48326 at the two points where the crankshaft rear oil seal meets the split line of the engine
block.
