SRX AWD V8-4.6L VIN A (2004)
3. Place the engine front cover in position on the crankcase.
4. Apply the thread locking compound GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the threads of the engine front cover bolts.
5. Install the engine front cover retaining bolts.
6. Notice: Refer to Fastener Notice.
Tighten the engine front cover bolts in the sequence shown.
Tighten the engine front cover bolts in proper sequence to 15 Nm (11 ft. lbs.).
7. Install the crankshaft balancer.
8. Install the water pump pulley.
Tighten the water pump pulley bolts to 10 Nm (89 inch lbs.).
