SRX AWD V8-4.6L VIN A (2004)
1. Install new O-rings to the auxiliary rear liquid line.
2. Install the auxiliary rear liquid line to the vehicle.
3. Install the auxiliary rear liquid line to the body retainers.
4. Connect the rear auxiliary A/C line to the front auxiliary front liquid line.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Tighten the liquid line fitting (1).
Tighten
Tighten the fitting to 9 N.m 80 lb in).
6. Connect the auxiliary rear liquid line to the auxiliary evaporator.
7. Install the auxiliary rear liquid line nut to the auxiliary evaporator.
Tighten
Tighten the nut to 9 N.m (80 lb in).
8. Install the engine exhaust.
9. Lower the vehicle.
10. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
11. Leak test the fittings of the components using J 39400-A.
