SRX AWD V8-4.6L VIN A (2004)
IMPORTANT: The auxiliary rear suction line splice area is located through the LH rear wheelhouse opening.
11. Locate the area where the auxiliary rear suction line will be cut.
12. Measure approximately 150.0 mm (5.9 in) from the sharp bend (a) on the auxiliary rear suction line.
13. Use a tubing cutter in order to cut the auxiliary rear suction line.
14. Loosen the auxiliary rear suction line to the auxiliary front suction line fitting (1).
15. Remove the auxiliary rear suction lines from the vehicle.
16. Remove and discard the O-rings from the auxiliary rear liquid lines
INSTALLATION PROCEDURE
IMPORTANT: The length of the replacement line must be the same as the section being replaced.
